Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
Chapter 1
Introduction
This manual covers the installation procedures for WAVE Mobile Radios and accessories required to
complete the radio system. The radio system consists of a control head, radio, antenna, microphone,
speaker, cabling, and accessories.
1.1
Mobile Radio Description
This chapter covers the basic dimensions of the dash mount trunnion of the mobile radio.
1.1.1
Dimensions
When installing the radio, plan the installation carefully and leave room for cabling and accessory
connections in the installed location and to the sides and top of the radio for the installation of the radio
into the trunnion with the appropriate hardware.
NOTICE: The measurement unit used is millimeter unless otherwise stated.
Figure 1: Front View of Dash Mount Trunnion for MOTOTRBO XPR 4000/4000e
208.3 mm
172.7 mm
6880309T23-FB
Chapter 1: Introduction
16