Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
The following figure shows a typical setup of a Base/Control Station configuration .
Figure 7: Example of a Base/Control Station Configuration
Speaker
Desk
Microphone
Power Supply
Wall-
outlet
Radio in
Desktop Tray
Line Cord
with Ground
Desktop
Power Cable
Antenna
Cable
Antenna Connector
Outdoor Antenna
Lightning Protector With
Quarter Wave Shorting Stub
6880309T23-FB
Chapter 1: Introduction
20