Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
For new or existing installations, use one of the mounting kits as specified in table below. Orient the
mounting trunnion.
Mounting Kit Motorola Solutions Part
Number
Motorola Solutions Part
Number
Low Profile Trunnion Kit (ships as part
of mobile radio package)
RLN6076_ RLN6469_
Low Profile Trunnion Kit (ships in a box
– intended for resale)
RLN6077_ RLN6466_
Standard Profile Trunnion Kit RLN6078_ RLN6467_
Key Lock Trunnion Kit RLN6079_ RLN6468_
DIN Mount RLN5933_ RLN6465_
Figure 11: Trunnion Orientation for Above or Below Mobile
1
Label Description
1 Radio Front
2.2.1
Dash Mount with Trunnion
Procedure:
1 Select the location to mount your radio on the transmission hump or under the dash.
NOTICE: When mounting the trunnion on the transmission hump take care that the
transmission housing is not affected.
2 Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3 Center punch the spots you have marked and realign the trunnion in position.
6880309T23-FB
Chapter 2: Installation Details for Standard Configurations
25