Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
Figure 14: Locking Kit (Optional)
1
Label Description
1 Lock
2.3
DIN Mount
This chapter explains the steps to install, mount, and remove the Mounting Frame.
2.3.1
Installing the Frame into the Dashboard
Procedure:
1 Open up the radio cut-out in the dashboard to ISO7736 specification (182 mm x 53 mm).
2 Insert the mounting frame into the cut-out and retain it by bending back the relevant fixing tabs
(using all six where possible). Check the orientation of the frame is correct by ensuring that the
word "TOP" is uppermost.
NOTICE:
The tabs are easily bent back by twisting a large flat-head screwdriver in the slot behind
the tabs.
For a more secure installation, the frame should also be secured with the appropriate
number of screws to the mounting conditions (min. 1).
The demounting tool can be used as an aid to mounting as well as demounting.
6880309T23-FB
Chapter 2: Installation Details for Standard Configurations
28