Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
3 Check the antenna location for any electrical interference.
4 Make sure that the mobile radio antenna is installed at least 30 cm (1 foot) away from any other
antenna on the vehicle.
NOTICE: Any two metal pieces rubbing against each other (such as seat springs, shift levers,
trunk and hood lids, exhaust pipes, and others) in close proximity to the antenna can cause
severe receiver interference.
2.7.2
Installing the Antenna
Procedure:
1 Mount the antenna according to the instructions provided with the antenna kit. Run the coaxial
cable to the radio mounting location. If necessary, cut off the excess cable and install the cable
connector.
NOTICE: Do not mount the antenna on metal surface.
2 Connect the antenna cable connector to the radio antenna connector on the rear of the radio.
Figure 18: Antenna Connections on the Back of the Radio
1 2
Label Description
1 Antenna Connector
2 GPS-Antenna Connector
3 In case of a GPS model, connect the GPS antenna to the GPS antenna connector on the rear of
the radio.
6880309T23-FB
Chapter 2: Installation Details for Standard Configurations
34