Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
Figure 19: Connection
4
3
2
1
Label Description
1 Mini-UHF Jack
2 Collar Pulled Back to Flange
3 Flange
4 Cable
2.8
Microphone Hang-Up Clip
This chapter explains the usage of Standard Hang-Up Clip.
2.8.1
Standard Hang-Up Clip
The hang-up clip must be within reach of the operator(s). Measure this distance before actually
mounting the bracket. Since the bracket has a positive-detent action, the microphone can be mounted
in any position. The microphone hang-up clip must be grounded.
Use the hang-up clip as a template to locate the mounting holes. To avoid interference when removing
the microphone, install the flathead screw in the top clip hole.
2.9
Completing the Installation
Complete the installation by connecting the power wires and plugging in the microphone cable to the
mobile.
6880309T23-FB
Chapter 2: Installation Details for Standard Configurations
36