Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
Figure 21: Pin Configuration of Rear Accessory Connector (as viewed from the rear of the
radio)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
D+
Vbus
SW B+
Spkr-
Tx Audio
Aux Audio Out 1 / RxD
Aux Audio Out 2 / TxD
GP5_1 (PTT)
GP5_2 (Monitor)
GP5_3 (Chan Act)
Emerg Sw
Ign Sense
D-
USB / MAP_ID Ground
MAP_ID_1
Power Ground
Spkr+
Audio Ground
Rx Audio
Ground
Ground
GP5_6
GP5_7
GP5_8
VIP_1 (Ext Alarm)
MAP_ID_2
Table 4: Rear Accessory Connector Pin Functions
Pin No. Pin Name Pin Function
1 USB+ USB + (Data)
2 USB- USB - (Data)
3 VBUS USB Power (5 V from USB ac-
cessory/cable)
4 USB/MAP_ID GDN USB/MAP_ID Ground
5 MAP_ID_2 Accessory Identifier
6 MAP_ID_1 Accessory Identifier
7 SW B+ Switched Battery Voltage
8 PWRGND Ground
9 SPKR- Speaker - (3.2 Ω minimum im-
pedance)
10 SPKR+ Speaker + (3.2 Ω minimum
impedance)
11 Tx Audio Rear External Microphone In-
put
1
12 Audio GND Audio Ground
1
This microphone signal is independent of the microphone signal on the front microphone con-
nector. The nominal input level is 80mVrms for 60% deviation. The DC impedance is 660 Ω
and the AC impedance is 560 Ω.
6880309T23-FB
Chapter 3: Options and Accessories Installation
38