Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
6 Before performing battery maintenance procedure, turn off the radio and remove the Fuse from
radio power supply. Reinsert the Fuse after battery maintenance is completed. The following
figure shows the location of the Fuse.
1
Item Description
1 Fuse location
6880309T23-FB
Chapter 4: Best Practices: Installation & Troubleshooting
46