Installation Guide
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Document History
- Related Publications
- Notations Used in This Manual
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Introduction
- Installation Details for Standard Configurations
- Options and Accessories Installation
- Best Practices: Installation & Troubleshooting
- 4.1 Check Wiring of Ignition and Radio Ignition Sensing
- 4.2 Check Physical Installation of Radio Ground and Radio Accessory Wiring
- 4.3 Improving the Electrical Quality of the Power and Ignition Lines
- 4.4 Jump-Start the Vehicle
- 4.5 Eliminate Noise/Howling from PA Speaker
- 4.6 Eliminating False Emergency Alert Triggering
- Appendix A: Replacement Parts Ordering
- Appendix B: Motorola Solutions Offices
- Glossary
- Analog
- Band
- Customer Programming Software
- Default
- Digital
- Digital Private-Line
- Dispatcher
- Federal Communications Commission
- Frequency
- General-Purpose Input/Output
- Global Navigation Satellite System
- Integrated Circuit
- kilohertz
- Liquid-Crystal Display
- Light Emitting Diode
- Motorola Digital Communications
- Megahertz
- Paging
- Printed Circuit Board
- Private-Line Tone Squelch
- Programming Cable
- Receiver
- Repeater
- Radio Frequency
- Signal
- Spectrum
- Squelch
- Time-out Timer
- Tone Private Line
- Transceiver
- Transmitter
- Trunking Priority Monitor Scan List
- Ultra-High Frequency
- Universal Serial Bus
Notice
Installation Requirements for
Compliance with
Radio Frequency (RF) Energy
Exposure Safety Standards
CAUTION: This radio is intended for use in occupational/controlled conditions, where users
have full knowledge of their exposure and can exercise control over their exposure to meet
FCC limits. This radio device is NOT authorized for general population, consumer, or any other
use.
To ensure compliance to RF Energy Safety Standards:
• Install only Motorola Solutions approved antennas and accessories.
• Be sure that antenna installation is per "Antenna Installation" of this manual.
• Be sure that the Product Safety and RF Safety Booklet enclosed with this radio is available to the
end user upon completion of the installation of this radio.
Before using this product, read the guide enclosed with your radio which contains important operating
instructions for safe usage and RF energy awareness and control for compliance with applicable
standards and regulations.
WARNING: For radios installed in vehicles fueled by liquefied petroleum gas, refer to the (U.S.)
National Fire Protection Association standard, NFPA58, for storage, handling, and/or container
information.
This radio has a transmitter Time-out Timer that disables the transmitter during a transmission after a
pre-defined time period, which by default is set to 60 seconds.
CAUTION: It is recommended NOT to change the default 60 seconds time period for the Time-
out Timer as the radio is intended for intermittent duty cycle operation.
For a list of Motorola Solutions-approved antennas and other accessories, visit http://
www.motorolasolutions.com.
WARNING: This equipment is compliant with Class A of EN55032. In a residential environment,
this equipment may cause radio interference.
6880309T23-FB
Installation Requirements for Compliance with
Radio Frequency (RF) Energy Exposure Safety Standards
7