User's Guide

During channel access, access or deaccess code, or extra
digits transmission, your radio responds to the On/Off ,
Volume Control, and Channel Selector buttons or knobs
only. A tone sounds for every invalid input.
During channel access, press to dismiss the call
attempt. A tone sounds.
NOTICE:
The access or deaccess code cannot be more than
10 characters.
Check with your dealer or system administrator for
more information.
6.10.5.1
Making Phone Calls
Follow the procedure to make Phone Calls on your radio.
1 Press the programmed One Touch Access button
to the predefined alias or ID.
If the entry for the One Touch Access button is
empty, a negative indicator tone sounds. If the
access code is not preconfigured in the Contact List,
the display shows Access Code:.
2
Enter the access code, and press to proceed.
The access or deaccess code cannot be more than
10 characters.
3 Press the PTT button to respond to the call. Release
the PTT button to listen.
4 Enter extra digits with the keypad if requested by the
call, and press to proceed.
If the call ends while you are entering the extra digits
requested by the call, your radio returns to the
screen you were on before initiating the call.
The Dual Tone Multi Frequency (DTMF) Tone
sounds. Your radio returns to the previous screen.
5
Press
to end the call.
6 Do one of the following:
• If the deaccess code was not preconfigured,
enter the deaccess code when the display shows
De-Access Code:, and press to proceed.
The radio returns to the previous screen.
English
379