User's Manual

21
1. Insert the main board into the housing, plac-
ing the audio jack into the housing first. Push
the board into the housing until it is properly
seated. Refer to Figure 3.
2. Align the three tabs of the front housing into
three slots the back housing.
3. Pivot the front and back housings together.
4. Make sure all rubber gaskets are properly
seated.
OTE: Make sure that the rubber gasket on the
back housing makes proper contact with
the front housing when fitting both hous-
ings together.
Antenna
Audio
Jack
Switch on PCB
Rubber
Figure 3.
Attenuator
(insert screwdriver here)
N