MISSION CRITICAL WIRELESS ADAPTER PMLN5792
Blank.
FOREWORD ! Caution Before using this product, read the operating instructions for safe usage contained in the Product Safety and RF Exposure booklet enclosed with your radio. ATTENTION! The radio is restricted to occupational use only to satisfy ICNIRP/ FCC RF energy exposure requirements.
English OPERATION Attaching the Mission Critical Wireless Adapter to the Radio's Universal Connector Below are the steps to attach the Mission Critical Wireless Adapter PMLN5792 to the radio’s universal connector: 1. Ensure that the radio is turned off before attaching the adapter to the radio. 2. Remove the universal connector cover from the side of the radio. 3. Insert the bottom hooked end of the adapter into the radio's bottom slot.
Tethered Screw Audio Routing Toggle Switch Spring Latch LED Blue Dot Bottom Hooked Bottom Slot End Figure 1 Mission Critical Wireless Adapter 2 English Top Slot
English Supported Bluetooth Devices • NTN2570A, HKXXXX Wireless Accessory Kit, NFP, 12" CABLE • NTN2573A, HKXXXX Wireless Accessory Kit, NFP, 9.
a.The adapter allows a maximum of 1 audio and 1 non-audio device to pair with it. b.If the maximum number of device is reached, the user needs to unpair the device. Refer to step 7 for unpairing procedure. 4. The adapter provides LED indication when successfully connected with the Bluetooth Headset Device .Refer to “LED Status Indication” on page 3. 5. Perform link check to verify the Bluetooth connection between the adapter and the Bluetooth device. Refer to respective Bluetooth device’s user manual. 6.
English 7. To replace with new Bluetooth device: a.Power OFF the Radio b.Press and hold the PTT button on the adapter while powering up the radio until the adapter provides LED indication. This indicates that the dongle has unpaired with the previously paired device and is ready to pair with the new device. Refer to “LED Status Indication” on page 3. c.Repeat steps 1 to 5 to pair a new Bluetooth device. Note: When step 7 is performed, it will erase all the previously paired device information.
Audio Routing Toggle Switch The toggle switch on top of the adapter allows the user to switch audio between the Mission Critical Wireless Adapter and the radio. • With the toggle switch positioned away from the radio, audio will be routed to the radio speaker, and the radio microphone is active during transmit. • With the toggle switch positioned towards the radio, audio will be routed to the Bluetooth headset earpiece, and the headset microphone will be active. The adapter and headset must be paired first.
m MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. © 2010 Motorola, Inc. All rights reserved.