Network Router User Manual
Table Of Contents
- Copyright
- Table of Contents
- Introduction
- CHAPTER 1 Overview of Major Capabilities
- CHAPTER 2 Basic Mode Setup
- CHAPTER 3 Advanced Setup
- Access the Expert Web Interface
- Links Bar
- Link: Configure
- Link: Connection
- Link: DHCP Server
- Link: IP Passthrough
- Link: NAT
- Link: IPSec
- IPSec VPN
- Link: Router Password
- Link: Time Zone
- Link: VLAN
- Overview
- Ethernet Switching/Policy Setup
- Link: Wireless
- Enable Wireless
- Wireless ID (SSID)
- Privacy
- Advanced Configuration Options (optional)
- WiFi Multimedia
- Wireless MAC Authorization (optional)
- Link: Status
- DSL
- ATM
- Ethernet
- IP
- LAN
- Wireless
- USB
- Logs
- User List
- Link: Diagnostics
- Link: Remote Access
- Link: Update Router
- From a Server
- Link: Reset Router
- Link: Restart Router
- Basic Mode
- Help
- CHAPTER 4 Basic Troubleshooting
- CHAPTER 5 Command Line Interface
- Overview
- Starting and Ending a CLI Session
- Using the CLI Help Facility
- About SHELL Commands
- SHELL Commands
- About CONFIG Commands
- CONFIG Commands
- Remote ATA Configuration Commands
- DSL Commands
- Bridging Settings
- DHCP Settings
- DMT Settings
- Domain Name System Settings
- IGMP Settings
- IP Settings
- Queue Configuration
- IPMaps Settings
- Network Address Translation (NAT) Default Settings
- Network Address Translation (NAT) Pinhole Settings
- PPPoE /PPPoA Settings
- PPPoE with IPoE Settings
- Ethernet Port Settings
- 802.3ah Ethernet OAM Settings
- Command Line Interface Preference Settings
- Port Renumbering Settings
- Security Settings
- SNMP Settings
- System Settings
- Syslog
- Wireless Settings (supported models)
- VLAN Settings
- VoIP settings
- UPnP settings
- DSL Forum settings
- Backup IP Gateway Settings
- VDSL Settings
- CHAPTER 6 Glossary
- Index
161
Factory Reset Switch
Factory Reset Switch
Lose your password? This section shows how to reset the Netopia Gateway so that you
can access the configuration screens once again.
☛ NOTE: Keep in mind that all of your settings will need to be reconfigured.
If you don't have a password, the only way to access the Netopia Gateway is the following:
1. Referring to the following diagram, find the round Reset Switch opening.
2. Carefully insert the point of a pen or an unwound paperclip into the opening.
3. Hold the button in until the “Power” LED turns RED and then hold it in until it turns
GREEN again.
If you don't hold it this long, the normal configuration will be cleared, but not all the con-
figuration info (default settings, etc.) – in some cases you may NOT want to clear all the
default settings, as well. This entire process takes approximately 10 seconds: approxi-
mately five seconds for the Gateway to reboot and the LED to turn RED; then approxi-
mately three seconds for it to turn GREEN again.
4. This will reset the unit to factory defaults and you will now be able to reprogram the
Netopia Gateway.
Factory Reset Switch: Push to clear all settings
Rear View