User guide

Scanner Settings C - 3
Barcode Settings
The Scanners icon provides dialog boxes in which you can tailor barcode scanner configurations and choose
the barcodes your scanner will recognize.
•Tap on Start>Settings> System>Scanners icon.
The parameters are preset with the default settings o
f the decoded scanner installed in the unit.
Scanner Options
The drop-down menu to the right of the Scanner option allows you to choose configurations for one of the
following scanner types, depending on what is installed in/on your hand-held: Decoded (internal), Decoded
(HHP), Decoded (Intermec ISCP), and Non-decoded Scanners.
The symbologies listed change to reflect the scanner you choose and the barcodes it supports. Always
defer to your barcode scanner’s programming manual
when in doubt about the availability or settings for
any parameter.
IMPORTANT To enable a newly-installed scanner, press and hold down the [FN]
key and the [ENTER/Power] key simultaneously for a minimum of
three seconds.
For information on configuring the Options, Translations, and Ports
settings, see Omnii.
NOTE Your Omnii comes preconfigured from the factory for internal scanner types. To
determine the type of scanner installed in your unit, go to
Start>Setting>System>System Properties icon.