User's Guide

Chapter 40
Remote Monitor
This feature is used to turn on the microphone of a target radio with a subscriber ID. You can use this
feature to remotely monitor any audible activity surrounding the target radio.
Both your radio and the target radio must be programmed to allow you to use this feature.
If initiated, the green LED blinks once on the target radio. This feature automatically stops after a
programmed duration or when there is user operation on the target radio.
For Other Systems, Remote Monitor comprises of two types:
• Remote Monitor without Authentication
• Remote Monitor with Authentication
When your radio turns on the microphone of a target radio with user authentication, a passphrase
is required. The passphrase is preprogrammed into the target radio through the radio programming
softwares.
40.1
Initiating the Remote Monitor
Procedure:
Perform one of the following actions:
Option Actions
Initiating Remote Monitor with
Contact List
From the menu, select Contacts→<required ID
or alias>→Remote Mon..
Initiating Remote Monitor with
Manual Dial
a From the menu, select Contacts→Manual Di-
al→Radio Number.
b Either enter the ID or alias, or edit the previous dialed
ID.
c Select Remote Mon..
If the request is successful, your radio shows the following indications:
• A positive tone sounds.
• The display shows a positive mini notice.
• The audio from the monitored radio starts playing for a programmed duration, and the display
shows Rem. Monitor. When the timer expires, an alert tone sounds and the LED turns off.
If the request is unsuccessful, your radio shows the following indications:
• A negative tone sounds.
• The display shows a negative mini notice.
MN007848A01-AB
Remote Monitor
141