User guide

General Radio Operation

Universal Connector Cover

The universal connector cover is located on the antenna side of the

radio. It is used to connect certain accessories to the radio.

Note: To prevent damage to the connector, shield it with the

connector cover when not in use.

Remove the Connector Cover

Attach the Connector Cover

1 Insert a flat-bladed

screwdriver into the area

between the bottom of the

cover and the slot below the

connector.

2 Hold the top of the cover with

your thumb while you pry the

bottom of the cover away

from the radio with the

screwdriver.

1 Insert the hooked end of the

cover into the top of the

connector. Press downward

on the cover’s top to seat it

into the slot.

2 Press the cover’s lower tab

below the connector until it

snaps in place.

94C05.book Page 20 Monday, July 5, 2010 7:32 PM