User manual

88
shielded, designed, or otherwise configured for RF
energy compatibility. In some circumstances, your
mobile device may cause interference with other
devices.
Follow Instructions to Avoid Interference Problems
Turn off your mobile device in any location where
posted notices instruct you to do so, such as
hospitals or health care facilities.
In an aircraft, turn off your mobile device whenever
instructed to do so by airline staff. If your mobile
device offers an airplane mode or similar feature,
consult airline staff about using it in flight.
Medical Devices
If you have a medical device, including an
implantable medical device such as a pacemaker or
defibrillator, consult your healthcare provider and the
device manufacturer’s directions before using this
mobile device.
Persons with implantable medical devices should
observe the following precautions:
• ALWAYS keep the mobile device more than
20 centimeters (8 inches) from the implantable
medical device when the mobile device is turned
ON.
• DO NOT carry the mobile device in the breast
pocket.
• Use the ear opposite the implantable medical
device to minimize the potential for interference.
• Turn OFF the mobile device immediately if you
have any reason to suspect that interference is
taking place.
Specific Absorption Rate (FCC & IC)
SAR (IEEE)
YOUR MOBILE DEVICE MEETS FCC AND IC LIMITS
FOR EXPOSURE TO RADIO WAVES.
Your mobile device is a radio transmitter and receiver.
It is designed not to exceed the limits for exposure to
radio waves (radio frequency electromagnetic fields)
adopted by the Federal Communications
Commission (FCC) and Industry Canada (IC). These
limits include a substantial safety margin designed to
assure the safety of all persons, regardless of age and
health.
The radio wave exposure guidelines use a unit of
measurement known as the Specific Absorption
Rate, or SAR. The SAR limit for mobile devices is
1.6 W/kg.
Tests for SAR are conducted using standard
operating positions with the device transmitting at its
highest certified power level in all tested frequency
bands. The highest SAR values under the FCC and IC
guidelines for your device model are listed below:
During use, the actual SAR values for your device are
usually well below the values stated. This is because,
for purposes of system efficiency and to minimize
interference on the network, the operating power of
your mobile device is automatically decreased when
full power is not needed for the call. The lower the
power output of the device, the lower its SAR value.
Head SAR WCDMA 1900 1.34 W/kg
Body-worn SAR LTE Band 4 0.67 W/kg