user manual

Installation 21
.
To install the Free-standing Pedestal Mount, perform the following steps (see Figure 13):
Step 1. Select the location to achieve optimal
functionality and use of the 8.4" Display.
Step 2. If screws and nuts are used for anchoring the
mount, mark the hole locations using the
base of the mount and drill four 5.5 mm holes into the dashboard.
Step 3. If self-tapping screws are used for anchoring the
mount, attach the mount to the
desired location and drive the screws into the dashboard.
Step 4. Connect the display to the VESA Plate and s
ecure using four screws and washers.
Step 5. Connect the display signal
cable and the power cable
to
the display.
Step 6. Using four screws, install
the display to
the pedestal
Mount.
Step 7. Adjust the display position.
Step 8. Route the Display Signal
and Pow
e
r cables down to
the CPU Box. Ensure that
the cables have enough
slack to move when the
display is tilted up/down or
swiveled.
For cable connections, refer to
steps 5 to 7
of “To assemble and
install the Display DIN Mount,
perform the following steps (see
Figure 16):” on page 24.
Be careful not to drill or drive screws into wires, circuits or
equipment located under the dashboard
The pedestal mount can be assembled to the VESA plate on
bo
th of it's base end sides.
It is very important to use spring washers when securing the
disp
lay to the Display Bracket.
!
Caution
Note
Note
Figure 13
8.4” Display - Free-standing pedestal mount
VESA Plate
0.22” D Screw Hole
M4, 16 Screw