user manual

34 MW810 Mobile Workstation Vehicle Installation Manual
Figure 26 shows an optional connection layout of the CPU Box with Extra Display, Video &
I/O Expansion Board option to peripheral devices, system and power.
Ensure that the cables are properly routed to preven
t damage to the cables and any operator
hazards. Connect the DC Power cables at the end of the connection process.
Important Note: Use the supplied rubber plugs to cover the unused receptacles.
ON
OFF
PWR
DISPLAY 2
USB
LAN LAN
USB
AUX
COM 1
LAN
DISPLAY 1
COM 4
VIDEO
AUX
MAIN
AUX
OUT
IN
MAIN
2
1
3
W-WAN
W-WAN
2
1
GPS
W-LAN
Figure 26
Optional Connection Layout of CPU Box with Extra Display, Video & I/O Expansion Board Option to
peripheral devices, system and power.
Vehicle
Power
System
GPS
Antenna
Ignition Sense Input
5 to 27V Power output.
1.5 Amps maximum
Display 1
Display 2
Wireless LAN
MIMO Antenna
Headset
Mobile DVR System
External Radio
1000 BASE-T LAN1 Network
Bluetooth
USB
USB
USB
USB
Bluetooth
RS232 Radio interface
Display Signal Cable
Display Signal Cable
Power Cable
Digital I/Os (GPIO
Ports)
CAUTION 
Do not connect or disconnect any peripheral device during the boot-up process or when
the CPU is in power-saving mode.
!
USB
USB
Fuse: 13.8VDC - 15A,
27.6VDC -10A
Fuse: 13.8VDC - 15A,
27.6VDC -10A
Fuse: 13.6VDC - 15A,
27.2VDC -10A
Audio
Line
out
1000 BASE-T LAN2 Network
802.11 n
W-WAN1
Antennas
Audio
Line
in
Power Cable
W-WAN2 is not in use
(Future Option)
3
2
1000 BASE-T LAN