user manual

42 MW810 Mobile Workstation Vehicle Installation Manual
Display 1 and 2 Connections
The DISPLAY 1 connector of the CPU Box can interface to a 3rd party LCD or CRT display
by DVI or RGB connection. To interface to a 3rd party display, use CPU Box Splitter Cable
P.N: FKN0009A.
The CPU Box graphics controller support resolutions up to 1280 x 1024 and the
simultaneou
s op
eration of two monitors, the analog RGB (DISPLAY1 connection) and
digital DVI (DISPLAY2 connection).
The MW810 Mobile Workstation displays have available USB 2.0 ports supporting transfer
rates
up
to 480 MB/s. When the CPU is connected to the old MW800 display, only USB 1.1
performance can be provided.
Table 5 details the pin layout of the DISPLAY 1 and 2 connection
To interface the MW810 CPU Box R2.0 to a legacy MW810 display
use:
• CPU Box R2.0 to Display (60 pin to 50 pin) adaptor cable P.N:
FKN000
3
• CPU Box R2.0 to Display (60 pin to 36 pin) adaptor cable P.N:
FKN000
11
When interfacing a legacy display to the MW810 CPU Box R2.0,
soft
ware installation is also required. (See MW810 Mobile Workstation,
R2.0, Administrator Guide P.N 6802988C42.)
The CPU Box graphic controller (Intel® HD Graphics 4000 Engine)
suppor
ts resolutions up to 1280x1024. When using MW810 display,
XGA resolution (1024 x 768) is recommended.
To avoid damage to the DISPLAY connectors on the rear panel of
the
CPU Box, connect the cable orientated to the right hand side (in
reference to the cable molded rib).
Table 5
DISPLAY 2 Connection - Pin Layout
Pin
No.
Signal
1 USB2P
2 USB2N
3 GND
Note
Note
!
Caution