Operation Manual

42
Using additional handsets
10. Using additional handsets
Upto5handsetscanberegisteredtoonebasestation.Additionalhandsets
mustberegisteredtothebasebeforeyoucanusethem.
• TheinstructionsdescribedbelowapplyspecicallytotheC2010handset.
Ifyouwishtoregisteranothermanufacturer’shandset,theinstructions
mayvary.Inthiscase,pleaserefertotheinstructionmanualofthe
additionalhandset.
• TheSystemPINisrequiredtoregisterorunregisterhandsets.Thedefault
PINis0000.
10.1 Registering an additional handset
NOTE
Handset batteries must be fully charged before you start to register. Hold
your handset close to the base during the registration process. Handsets that
were supplied with your C2010 base are already preregistered.
Onthebase:
1. Pressandhold
untilthebaseemitsadoublebeep.Thebasewill
remaininregistrationmodefor90seconds.
Onthehandset:
1. Press
Menu ,scroll to Registration andpress Select .
2.
Register Handset ishighlighted.Press Select .
3. Basesaredisplayed.Ifnecessary,scroll
or toanewbaseyouwish
toregistertheC2010handsettoandpress
Select .
4. EnterthesystemPINandpress
OK .
5. Thedisplayshows
Searching Base X .
6. Whenregistrationissuccessfulthedisplayshows
Handset Registered andyou
hearaconrmationbeep.
NOTE
If registration is not successful the rst time, please repeat the process again
in case the base registration period ran out of time. If the base is not found
after a few seconds, the handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, registration will fail.
You must de-register a handset before you can register a new one.
10.2 Register a different make of handset to your C2010 base
IMPORTANT
DECT GAP Prole only guarantees that basic calling functions will work
correctly between different makes / types of handset and base. There is a
possibility that certain devices such as Caller ID will not work correctly.