Operation Manual

56
Text messaging
Writing tips
Press Clear todeleteincorrectcharacters.
Use or tomovethecursorthroughthetext,ifyouwanttoinsert/delete
text.
Upper & lower case
Press
to switch between upper case and lower case letters.
Maximum number of characters in a text message is 160 (Short). The display
shows a character countdown from 160 down to 0 (Unless message size is
set to 612 characters [Long]).
NOTE
If the text is unsuccessful, the message
Message Sending Failed! will be displayed.
In order to send and receive text messages you must not withhold your
number.
13.3 Standard text entry
Withstandardtextentryyoucanenterawordbypressingeachletterbutton
anumberoftimestodisplaythecharacteryouwantonthe
screen.Forexample,towritetheword‘Hello’,press twice, 
twice, threetimes, threetimesand threetimes.
13.4 Receiving and reading text messages
YourC5010Acanstoreuptoatotalof50shortmessagesacrossallhandset
Outboxes,DraftsboxesandInboxes.
Whenyoureceiveanewtextmessage,thedisplayshows You have X new messages .
Ifyoupress Back ,thescreenreturnstostandbymodeandthe iconis
displayed.
Do you have two text phone bases connected to the same phone line?
If you have two text phone base stations plugged into one line, you are likely
to experience problems receiving text messages. Normally, only one SMS
enabled base unit (DECT or cordless) can be plugged into any line.
If you do want to use two base units and still receive written text you must
delete receive service centre number from one of the base stations. To do
this on your C5010A, see page 59.
This will allow you to send text via either base station but texts will only be
received on the product with the active receive centre number.
If the base unit with the active receive centre number is a DECT product then
all handsets registered to it will be able to receive text messages.
Memory full alert
If the text mailboxes are full when you attempt to write a new message the
display shows
Memory Full Delete Messages . You must delete messages before you