Switch User Manual

Cajun P880 Routing Switch Installation Guide 2 - 27
To enable Fast Start for ports on a module associated with a selected
bridge:
1. In the System Configuration section of the Web Agent
window, click Modules & Ports. The Module Information
dialog box opens.
2. In the Switch Ports column, click on the switch port number
listed for the selected module. The Switch Ports dialog box
opens.
3. To set Fast Start mode on individual ports, in the Name column,
click the port name for the selected module. The Switch
Port Configuration dialog box opens.
Or
To set Fast Start mode on all ports in a module, click All Module
Switch Port Configuration. The Switch Port Configuration on
All Ports dialog box opens.
4. From the Fast Start pull-down menu, select Enable to enable
Fast Start mode on the selected module ports.
5. Click APPLY to save your changes, or CANCEL to clear your
selection.
Using the All Ports Configuration Dialog Box
The All Ports Configuration dialog box allows you to apply the same
parameter settings to all switch ports in a module using a single
command.
To set all switch ports in a module using a single command:
1. In the System Configuration section of the Web Agent
window, select Modules & Ports. The Module Information
dialog box opens.
2. In the Ports column, click the number of ports listed for the
module you want to configure (for example, 10 for 100BASE-
FX). The Physical Port Configuration dialog box opens.
3. Click All Module Ports Configuration at the bottom of the
dialog box. The All Ports Configuration dialog box opens.
4. Select the port on which you want your changes to occur.