user manual

Index
IN-10
I
N
D
E
X
BOOTP
address determination and bootfile
selection 4-20
protocol module 4-20
Bootstrap
and Halt (BH) 4-16
Operating System (BO) 4-15
Protocol (BOOTP) 4-20
braces 5-3
break 4-11
BREAK key 4-11
breakpoint and tracing capabilities 4-2
breakpoint during execution of the user
program 5-2
bug operational parameters A-3
byte
definition 1-3
ordering 1-3
C
C programming language 4-4
cable(s) 3-20
calling system utilities from user pro-
grams 5-9
card slot selection 3-15
CCS
(SCSI Common Command Set) B-2
CD2401 Serial Controller Chip (SCC)
2-18, 3-21
change clock speed D-5
changing parameter table 4-18
character input/output 5-9
chassis ground E-7
chassis preparation 3-15
checksum A-2
precautions 4-4
CLCC (EPROM) 2-13
Clear To Send (CTS) 3-22
clock speed calculation failure 4-12
CLUN (controller LUN) B-2, C-1
CLUN/DLUN combinations 4-15
command
descriptions 5-4
facilities 4-2
identifier 5-3
line 5-1
command parameters
IOT B-4
commands
diagnostic utilities 4-26
commands/prefixes, diagnostic monitor
4-25
comparison with M68000-based firm-
ware 4-4
confidence test failure 4-12
configuration, default disk/tape control-
ler B-2
configuration, hardware 3-8
Configure (CNFG) and Environment
(ENV) commands A-1
Configure Board Information Block (CN-
FG) A-1
connector P2 5-8
connectors 2-7
console port 5-7
console terminal D-1
control
addressing modes 5-5
and status bit definitions 1-4
bit 1-4
controller B-1
command packets 4-16
LUN (CLUN) B-2, C-1
converting protocol addresses to local
area network addresses 4-20
count 5-4
CPU Register Rnn 5-6
CPU/MPU registers 5-11
CR20 5-11
creating a program with the assem-
bler/disassembler 5-8
CTS (Clear To Send) 3-22
CTS/RTS E-4