user manual

3-2
Hardware Preparation and Installation
3
Overview of Startup Procedure
The following list identifies the things you will need to do before
you can use this board, and where to find the information you need
to perform each step. Be sure to read this chapter and all Caution
notes, and have the related documentation with you before you
begin.
Table 3-1. Startup Overview
Stage What you will need to do... Refer to...
On
page...
1 Prepare the MVME187. Preparing the
Hardware
3-5
Ensure that EPROM devices are properly
installed in their sockets.
Checking the
187Bug EPROMs
3-7
ConÞgure adapters and MVME712X
transition modules.
The userÕs manual you
received with your
MVME712X module
Install/remove jumpers on headers. Jumper Settings 3-7
2 Prepare the chassis. Preparing the
MVME187 for
Installation
3-14
Turn power off to chassis and peripherals. The userÕs
manual you
received with
your chassis
3-15
Disconnect AC power cable.
Remove chassis cover.
Remove Þller panels from card slots.
3 Install your MVME187 in the chassis. Installing the
Hardware
3-16
Remove IACK and BG jumpers from
backplane.
Slide the module into the chassis and
fasten it securely.