user manual
3-14
Hardware Preparation and Installation
3
Preparing the MVME187 for Installation
Refer to the setup procedures in the manuals for your particular
chassis or system for additional details concerning the installation
of the MVME187 into a VME chassis.
Table 3-7. MVME187 Preparation Procedure
Step Action
1 Install/remove jumpers on headers according to the Jumper Settings in this
chapter and as required for your particular application.
❏ Jumpers on header J1 affect 187Bug operation as listed in Jumper
Settings. The default condition is with all eight jumpers installed
❏ A jumper installed/removed on header J2 enables/disables the
system controller function of the MVME187.
❏ Install jumpers on headers J7 and J8 to configure serial port 4 to
use clock signals provided by the TRXC4 and RTXC4 signal lines.
2 ConÞgure adapters and transition modules according to the MVME712X
transition module
user's manuals.
3 Ensure that EPROM devices are properly installed in their sockets.
❏ Factory configuration is with two EPROMs installed for the
MVME187Bug debug monitor, in sockets XU1 and XU2.