Laptop User Manual

Debugger Commands Firmware
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
111
The later is accomplished by entering HE, followed by a space, followed by the test category
description (e.g., UART), followed by a carriage return.
Table 5-1 Debugger Commands
Command Description
AS Assembler
BC Block of Memory Compare
BF Block of Memory Fill
BFL Flash Board Fail LED If Diagnostic Errors
BI Block of Memory Initialize
BM Block of Memory Move
BS Block of Memory Search
BR Breakpoint Insert
BV Block of Memory Verify
CACHE Modify Cache State
CM Concurrent Mode
CNFG Configure Board Information Block
CS Checksum a Block of Data
CSAR PCI Configuration Space READ Access
CSAW PCI Configuration Space WRITE Access
DC Data Conversion and Expression Evaluation
DS Disassembler
DU Dump S-Records
ECHO Echo String
ENV Set Environment to Bug/Operating System
FORK Fork Idle MPU at Address
FORKWR Fork Idle MPU with Registers
G "Alias" for "GO" Command
GD Go Direct (Ignore Breakpoints)
GEVBOOT Global Environment Variable Boot - Bootstrap Operating System
GEVDEL Global Environment Variable Delete
GEVDUMP Global Environment Variable(s) Dump (NVRAM Header + Data)
GEVEDIT Global Environment Variable Edit
GEVINIT Global Environment Variable Area Initialize (NVRAM Header)
GEVSHOW Global Environment Variable Show
GN Go to Next Instruction
GO Go Execute User Program
GT Go to Temporary Breakpoint