Laptop User Manual

Configuring the PPCBug Parameters CNFG and ENV Commands
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
153
Field Service Menu Enable [Y/N] = N?
Probe System for Supported I/O Controllers [Y/N] = Y?
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Network PReP-Boot Mode Enable [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI Identifier = "07"?
Y Display the field service menu.
N Do not display the field service menu. (Default)
Y Accesses will be made to the appropriate system busses (e.g., VMEbus, local MPU
Bus) to determine the presence of supported controllers. (Default)
N Accesses will not be made to the VMEbus to determine the presence of supported
controllers.
Y NVRAM (Prep partition) header space is initialized automatically during board
initialization, but only if the PReP partition fails a sanity check. (Default)
N NVRAM header space will not be initialized automatically during board initialization.
Y Enable PReP-style network booting (same boot image from a network interface as from
a mass storage device.)
N Do not enable PReP-style network booting. (Default)
Y SCSI Bus is reset on debugger setup.
N SCSI Bus is not reset on debugger setup (Default)
Y Asynchronous SCSI Bus negotiation. (Default)
S Synchronous SCSI Bus negotiation.
N None
W Wide SCSI (16-bit bus)
N Narrow SCSI (8-bit bus). (Default)