Cordless Telephone User Manual

34 Help
9. Help
Charging
The icon is not scrolling when the handset is placed
on the base
• Bad battery contact – move the handset slightly
• Dirty contact – Clean the battery contact with a cloth
moistened with alcohol
• Battery is full – no need to charge
Calls
No dialling tone
• No power – check the connections. Reset the phone:
unplug and plug back in the mains
• Batteries are empty – charge the batteries for at least 24
hours
• You are too far from the base – move closer to the base
• Wrong line cable – use the line cable provided
• Line adaptor (when needed) is not connected to the line cord
– connect the line adaptor (when needed) to the line cord
Poor audio quality
The base is too close to electrical appliances, reinforced
concrete walls or metal doorframes – move the base at least
one metre away from any electrical appliances
The
icon is blinking
• Handset is not registered to the base – register the
handset to the base
• You are too far from the base – move closer to the base
• Switch OFF the Eco mode.
No ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller Line Identification (CLI) service
does not work
Check your subscription with your network operator
Phonebook
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory
Display
No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base power supply.
• If LED is not lit up, then try disconnecting and connecting
the base power supply.