User guide

16 Call Waiting
EN
9. Call Waiting
You must subscribe to your network’s Caller Display service for
Call Waiting to work. A quarterly fee may be payable.
1. During a call, you hear a soft beep in the earpiece and the
display shows the number of the caller or the name if it
matches an entry in your phonebook. If these are not
available, the display shows Call Waiting .
2. Press R to put your current caller on hold and speak to
the new caller.
3. Press R again to switch between both callers (In some
countries, it is required to dial R + 2).
4. Press > to finish the current call or > to end both calls.
10. Voicemail
If you have subscribed to your network operator’s voicemail
messaging service, your handset can inform you when you
receive new voicemail.
If you have new voicemail, You have new voicemail is displayed.
• Press Listen to dial the voicemail number preset on the
handset. If your voicemail number is different to the number
stored in the handset, you can manually dial your preferred
voicemail number.
• Or press Back to listen to your voicemail at a later time. A
reminder icon will be displayed.
11. Room Monitor
You can use your D1100 handset to monitor the sounds in
another room. If the sounds reach a certain level the handset
will automatically dial out to a preset external number or to
another handset. When the Room Monitor is set to On , the
handset will display Room Monitor On and only the microphone will
be active to monitor the sound levels in the room. Both the
speaker and receiver will be set to Off and the handset will not
ring if there’s any incoming call.
To switch Room Monitor On
1. Press Menu , scroll d to Extra then press Select . Room Monitor is
highlighted. Press Select . Mode will be highlighted.
2. Press Select , scroll d to On then press Select . Set to ON is
displayed for 2 seconds. The handset returns to idle screen
and disply as Room Monitor On .
To switch off Room Monitor press Off .
To change the monitor level
The monitor level can be set to High or Low, the default setting
is "Low".
To increase the sensitivity of the Room Monitor:
1. Press Menu , scroll d to Level , press Select and scroll u or d to
select Low or High setting.
To set the dial out number
1. Press Menu , scroll d to Call to and press Select .
2. Use the u or d key to select External or Internal .
External
1. Press Select and Enter Number: prompt will be displayed.
2. Enter the number and press Save . Saved will be displayed.
When Room Monitor is switched on and the sound level
reaches a certain level the number will be automatically
dialled.
Internal
1. Press Select and the registered handset will be listed, for
example "Handset 2".
2. Scroll u or d to select the handset the Room Monitor will call
if the noise levels reach a certain level.
3. Press Select and Set to handset 2 is displayed.
NOTE
If only one handset is registered the display prompts "Not
available" and returns to the previous screen. You must register
additional handsets before the handsets will be displayed and
make Internal calls.
NOTE
If the Room Monitor is triggered to call a handset or number and
the called handset is on a call, an alert tone of 3 beeps will be
heard. If the Room Monitor is triggered continuously the alert
beap will be emiitted every 5 seconds.
WARNING
This product is not intended for use as a baby safety device and
is not a substitute for adult supervision.