Operation Manual

9
English
7. Using your phone
Make a call
Press . The symbol is displayed. When you hear the
dial tone, dial the number you want. The number is shown in
the display.
After a short delay the call timer will start timing the call.
Adjust the earpiece/receiver volume
during a call
Press or to adjust the volume. There are five levels.
Preparatory dialling (pre-dial)
1. In standby mode, enter the number to be dialled.
The number is displayed.
You can enter numbers up to 32 digits. Press to delete
any incorrect digits.
Press and hold to delete all digits.
2. Press or to dial the displayed number.
Handset range
The handset range is up to 300 metres outdoors and up to
50 metres indoors (in ideal conditions).
If the handset is too far away from the base, during standby,
"
SEARCHING " appears and the symbol will flash. During a call
you will hear a warning tone and the call is terminated. You will
need to mover closer to the base for clearer reception and to
avoid being disconnected.
Call timer
When you make or receive a call, a short while after the line is
connected the call timer will show the duration of the call in the
display in hours, minutes and seconds.
Hands free mode
You can use hands free mode to talk to your caller without
holding the handset to your ear. You can speak into the
handset microphone and listen over the loudspeaker.
Hands free also enables other people in the room to listen in to
the conversation.
During a call:
1. Press . The symbol is displayed while in hands free
mode.
2. Press again to go back to the normal talk mode.
End a call
Press .
Or
Place the handset back on the base.
Make internal call , enter internal handset
number.
Answering machine ON/
OFF
(on base).
Play/ Stop your
messages.
Function Button press
Allegro_CID TAD.book Page 9 Tuesday, January 15, 2008 4:30 PM