Installation Instructions
Table Of Contents
- DCT 2000 Installation Manual
- Caution | Compliance | Copyright
- Contents
- Section 1 | Introduction
- Section 2 | Overview
- Section 3 | Installation
- Before You Begin
- Installing the DCT 2000
- Standard Cabling Diagram
- STARFONE Module Cabling Diagram
- Standard VCR Cabling Diagram
- RF Bypass Switch VCR Cabling Diagrams
- A/B In Module Cabling Diagrams
- Dual A/B-RF Bypass Module Cabling Diagrams
- Composite Baseband and S-Video Cabling Diagrams
- Stereo Cabling Diagram (Baseband)
- Dolby Digital Cabling Diagrams
- Operational Check
- Section 4 | Adding the IR Blaster Option
- Section 5 | Troubleshooting
- Appendix A | Specifications
- Appendix B | Diagnostics
- Accessing Diagnostics
- Navigating the Diagnostics
- d 01: DCT 2000 General Status
- d 02: Out-of-Band Receiver Status
- d 03: In-Band Receiver Status
- d 04: In Band Error
- d 05: Unit Address
- d 06: Firmware Version
- d 07 Current-Channel Status
- d 08: Renewable Security System
- d 09: Upstream Modem Status
- d 10: Application Code Modules
- d 11: Memory Status
- d 12: Keyboard Diagnostics
- d 13: Interactive Info – OSD
- d 14: MAC Frequency – OSD
- Abbreviations and Acronyms
2
22
2-
--
-8
88
8 Overview
DCT 2000 Installation Manual
Installing Batteries in Remote Control
Before using the remote control, you must install two AA (1.5 V) alkaline batteries. Figure 2-5
illustrates battery access on the back of the remote control.
To install batteries in an DRC 400:
1 Press and slide the battery compartment cover off.
2 Place the batteries in the compartment; be careful to observe the correct polarity.
3 Slide the battery compartment cover back into place.
Battery installation will vary with each style of remote control. Refer to the user instructions
includ ed with your r emote control for installin g batteries.
Figure 2-5
Back view of remote control
+
+