Installation Instructions
Table Of Contents
- DCT 2000 Installation Manual
- Caution | Compliance | Copyright
- Contents
- Section 1 | Introduction
- Section 2 | Overview
- Section 3 | Installation
- Before You Begin
- Installing the DCT 2000
- Standard Cabling Diagram
- STARFONE Module Cabling Diagram
- Standard VCR Cabling Diagram
- RF Bypass Switch VCR Cabling Diagrams
- A/B In Module Cabling Diagrams
- Dual A/B-RF Bypass Module Cabling Diagrams
- Composite Baseband and S-Video Cabling Diagrams
- Stereo Cabling Diagram (Baseband)
- Dolby Digital Cabling Diagrams
- Operational Check
- Section 4 | Adding the IR Blaster Option
- Section 5 | Troubleshooting
- Appendix A | Specifications
- Appendix B | Diagnostics
- Accessing Diagnostics
- Navigating the Diagnostics
- d 01: DCT 2000 General Status
- d 02: Out-of-Band Receiver Status
- d 03: In-Band Receiver Status
- d 04: In Band Error
- d 05: Unit Address
- d 06: Firmware Version
- d 07 Current-Channel Status
- d 08: Renewable Security System
- d 09: Upstream Modem Status
- d 10: Application Code Modules
- d 11: Memory Status
- d 12: Keyboard Diagnostics
- d 13: Interactive Info – OSD
- d 14: MAC Frequency – OSD
- Abbreviations and Acronyms
Installation 3
33
3-
--
-17
1717
17
DCT 2000 Installation Manual
Using this configuration the audio/video signals are passed through the digital receiver to
enable the VCR record and playback features. Figure 3-17 illustrates audio/video connections
for a Dolby Digital receiver:
Figure 3-17
Audio through Stereo Receiver
RF
IN
CABLE IN
TO RF IN
TV Pass Card
S-VIDEO
BAND
IR
SPEED
HIG H OUT OF
SWITCHED
60Hz
500W M AX
10 5-12 5V
4A MAX
TO
TV/VCR
DATA
R
AUX AUDIO IN SPDIF
AUD IO OU T
VIDEO
L
See appropriate cable diagram
VIDEO
OUT
SVIDEO
OUT
AUDIO
OUT
AUDIO
IN
L
L
R
R
CABLE IN
CABLE OUT
VIDEO
IN
SVIDEO
IN
TV
CABLE IN
VIDEO
IN
SVIDEO
IN
AUDIO
IN
LR
AUDIO
OUT
LR
Either or
Either or S-Video
or
Baseband Video
DIGITAL
RECEIVER
Video 2
Video 1
In
S-Video
Coaxial
Optical
Monitor
out
VCR
Video
In
Out