Installation Instructions
Table Of Contents
- DCT 2000 Installation Manual
- Caution | Compliance | Copyright
- Contents
- Section 1 | Introduction
- Section 2 | Overview
- Section 3 | Installation
- Before You Begin
- Installing the DCT 2000
- Standard Cabling Diagram
- STARFONE Module Cabling Diagram
- Standard VCR Cabling Diagram
- RF Bypass Switch VCR Cabling Diagrams
- A/B In Module Cabling Diagrams
- Dual A/B-RF Bypass Module Cabling Diagrams
- Composite Baseband and S-Video Cabling Diagrams
- Stereo Cabling Diagram (Baseband)
- Dolby Digital Cabling Diagrams
- Operational Check
- Section 4 | Adding the IR Blaster Option
- Section 5 | Troubleshooting
- Appendix A | Specifications
- Appendix B | Diagnostics
- Accessing Diagnostics
- Navigating the Diagnostics
- d 01: DCT 2000 General Status
- d 02: Out-of-Band Receiver Status
- d 03: In-Band Receiver Status
- d 04: In Band Error
- d 05: Unit Address
- d 06: Firmware Version
- d 07 Current-Channel Status
- d 08: Renewable Security System
- d 09: Upstream Modem Status
- d 10: Application Code Modules
- d 11: Memory Status
- d 12: Keyboard Diagnostics
- d 13: Interactive Info – OSD
- d 14: MAC Frequency – OSD
- Abbreviations and Acronyms
3
33
3-
--
-18
1818
18 Installation
DCT 2000 Installation Manual
Operational Check
The operational check tests the communication link between the remote control and the
DCT 2000. The procedures verify the DCT 2000 response to remote control commands.
Table 3-2 lists the operational check procedures:
Table 3-2
Operational check
Feature Testing Procedure
Power on
§ Press POWER to turn on the DCT 2000.
§ Turn on the TV and tune it to the output channel of the DCT 2000 (channel 3 or 4).
Channel Selection
§ Scan through the channels using the CHANNEL
keys on the DCT 2000 and the CHANNEL + -
keys on the remote control.
§ Tune to several channels by entering the channel number with the numeric keys on the remote
control.
Volume Control
§ Use the TV volume control to adjust the sound volume to a moderate level.
§ Press VOLUME + - on the remote control to increase the volume to its upper limit, lowest level, and
to a comfortable level.
§ Press MUTE to turn the sound completely off. Press MUTE again to restore the sound.
If the DCT 2000 does not operate properly, refer to Section 5, “Troubleshooting.”