Cordless Telephone User's Manual
24 Using the phone
3.20.3 Three-party conference call
1.
During an external home call, press MENU.
- Your caller is put on hold.
2.
Press VOL+ or REDIAL/VOL- to select the handset you
want to call.
3.
Press MENU to call the handset.
4.
When the other handset answers the intercom call,
press MENU on the calling handset to set up the
conference call.
5.
Press /BACK on any handset to hang up three-
party conference and leave the other handset in
external line with the caller.
3.21 Set the dial mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2.
Press MENU to select
DIAL MODE
.
3.
Press MENU and VOL+ or REDIAL/VOL- to select
TONE
or
PULSE
.
4.
Press MENU to save.
NOTE
If pulse mode is selected, press TONE/* to switch from pulse
to tone dialing temporarily when dialing out. After the call is
ended, the dial mode will change back to pulse.
3.22 Set the Flash Time
The default flash time is
600MS
. It is unlikely that you should
need to change this setting unless advised to do so.
1.
Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2.
Press MENU and then VOL+ or REDIAL/VOL- to select
FLASH TIME
.
3.
Press MENU and then VOL+ or REDIAL/VOL- to the
flash time you want. (8 options are available:
90
,
100
,
110
,
250
,
300
,
400
,
600
and
700MS
)
4.
Press MENU to save.