User`s guide

20 Using the Phone
3.14.3 Three-party conference call
1. During an external call, press INT.
- Your caller is put on hold.
2. Press VOL+ or REDIAL/VOL- to select the handset you
want to call.
3. Press MENU to call the handset.
4. When the other handset answers the intercom call,
press MENU on the calling handset to set up the
conference call.
5. Press /BACK on any handset to end a three-party
conference call and leave the other handset engaged
with the caller.
NOTE
During an external call, pressing /FLASH or
/SPEAKER on any handset will join in the call and set up
a conference call.
3.15 Setting the dial mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS .
2. Press MENU to select
DIAL MODE .
3. Press MENU and then VOL+ or REDIAL/VOL- to select
TONE or PULSE .
4. Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from
pulse to tone dialing temporarily when dialing out. After the
call is ended, the dial mode will change back to pulse.
3.16 Setting the flash time
The default flash time is 600MS . It is unlikely that you should
need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS .
2. Press MENU and then VOL+ or REDIAL/VOL- to select
FLASH TIME .
3. Press MENU and then VOL+ or REDIAL/VOL- to the
flash time you want. (8 options are available :
90 , 100 , 110 ,
250 , 300 , 400 , 600 and 700MS )
4. Press MENU to save.