Instruction manual

DSR-4550 47
Operating the DSR-4550
GigE Menus
Use the GigE menus is to configure the GigE port. To access the GigE menus, press
ENTER button to return to the main top-level menu (shown below).
Press the
4
buttons until the cursor is at the IP label, and press the ENTER button.
The DSR-4550 displays the first sub-menu within the IP menus. Follow the
procedures provided to access the various GigE menus within the IP menu structure.
GigE MAC Address Menu
Use the following procedure to view the GigE MAC address for the upper Ethernet
port on the back panel of the DSR-4550. The GigE MAC address is represented in a
hexadecimal format and non-editable.
Press the

buttons until the Port GigE menu appears (shown below).
GigE IP Address Field
Use the following procedure to set and view the GigE IP address (range:
000.000.000.000 to 255.255.255.255) for the upper Ethernet port on the back panel
of the DSR-4550. The address is represented in the common dotted-decimal format.
Contact the network administrator for details about configuring the GigE port for
operation on your local network.
Press the

buttons until the GigE IP Address menu appears (shown below).
Press the
4
button until the cursor is at the Address label, and press the ENTER
button to move into the field. Use the
4
buttons to select the digit to change and
then, while the cursor is on that digit, press the

buttons to display the desired
value. Repeat this process for each applicable digit to be changed.
Important: Do not configure the IP Address of the 10/100 and GigE to be on the
same subnet.
Press the ENTER button to confirm the selection and exit the field.
E Install Channel IP Status Diag
DSR-4550
Read-only
PORT GigE MAC Address
E hh-hh-hh-hh-hh-hh
E 192.168.000.100
PORT GigE IP Address