User guide

Release Notes

Router Control

• [Ref. #23109] After downgrading from iControl version 3.50 to an earlier version, if you

attempt to upgrade back to iControl version 3.50, the upgrade may not work.

Workaround:

Contact Miranda Technical Support (see "Contact Us", on page 69).

•

[Ref. #22986] When a Backup Application Server takes over a Main, permissions on the Web

Pages will no longer work if both of the following conditions are true:

• the LDAP server is enabled on the Main

• the Autofailover function is NOT configured to take over the Main IP address

Workaround:

Reset the permissions on the Web Pages of the Backup Application Server.

You can change the permissions in iC Creator. Also, you must reconfigure the LDAP referrals

if they exist on the Webmin Security page (see Configuring LDAP on an Application Server in

the Access Control chapter of the iControl User’s Guide).

•

[Ref. #22984] In situations where you are running a version of iControl earlier than 3.40 and

are upgrading to a later version, replication data will not survive the upgrade.

After an upgrade from a version prior to Version 3.40 to a later version, you must re-enter

replication data including the addition of Application Servers in the Redundancy Groups,

the desired replication frequencies, and the desired Extra IP.

Router Control

 [Ref. #ICONTROL-15929] If your router is an NV9000 running software version 5.2.4 or earlier,

your controller and overall router control may stop functioning.

Workaround:

1. Log into the Application Server via secure shell (SSH).

2. In a text editor, open the

rtr_serv file, found at the following location:

/usr/local/iControl/bin/rtr_serv

3. Edit the line DEF_OPTIONS=”${DEF_OPTIONS} by adding the following to the end of this

line:

‐Dcom.miranda.icontrol.routers.common.device.thread.sleep.enabled=false

‐Dcom.miranda.icontrol.routers.nv9000.max_alias_set=0‐

Dcom.miranda.icontrol.routers.nv9000.max_number_categories=0"

4. Restart the router service.

•

[Ref. #28342] When there are multiple routers on a network with the same router name,

Matrix and Single Bus views in iC Router Control may open with disabled Level buttons, a

Note: If the Backup is configured to reuse the Main’s IP address, this issue does not

occur.

Note: This is a single line of code.