Satellite TV System User Manual

This Motorola document is intended to assist an installer on installation, download, and activation process for
the DSR550 satellite receiver set-top box (STB).
Record STB
unit address

Please record the STB unit address (UA) located on the
label on the rear panel of the STB. It is in the format:
000-XXXXX-XXXXX-XXX. This is required for
authorization later in the process.
9
U/A: 000 - __________ - __________ - ______
Initial
Assumptions

Outdoor electronics are installed and peaked at the Rainbow
1 satellite. Antenna and diplexor are properly wired to
STB.

STB is wired to television via RCA or remod outputs for
installation process only.

HD Component connections should be wired for Final
Configuration.
Plug in STB

The STB will require less than 1 minute to fully power up.
When the power up is completed, a Setup Options screen
will appear.
Verify
Smartcard

Open up the smartcard front panel on the STB to verify that
the smartcard is in place. If no smartcard is present, please
notify Installs, Inc. of missing smartcard. A missing
smartcard will prevent video from being viewed.
Tune
Satellite

From the Setup Options screen menu, use the remote
control unit (RCU) to select option 4. Direct Tune to 255.
Verify DCII
Signal

Wait about 1 minute. A green satellite dish icon will appear
on the STB front panel display. This indicates that you
have acquired the correct Rainbow 1 signal are ready to
receive authorization. If the icon remains red, it indicates a
problem with antenna dish pointing angle, or the wiring
between the antenna electronics and the STB.

If the green satellite dish icon does not appear, you can
2
P
P
A
A
G
G
E
E
1
1
O
O
F
F
4
4