Quick Start

margin designed for the safety of all persons, regardless of age or health, and to
account for any variations in measurements.
The exposure standard for mobile devices employs a unit of measurement
known as the Specific Absorption Rate (SAR). The IEEE SAR limit set by the FCC
and by the Canadian regulatory authorities is 1.6 watts per kilogram (W/kg),
averaged over one gram of tissue. Tests for SAR are conducted using procedures
accepted by the FCC and by Industry Canada with the mobile device transmitting
at its highest certified power level in all tested frequencies. Although the SAR is
determined at the highest certified power level, the actual SAR level of the
mobile device while operating can be below the maximum value. This is
because the mobile device is designed to operate at multiple power levels so as
to use only the power required to reach the network. In general, the closer you
are to a wireless base station, the lower the power output.
Before a mobile device is available for sale to the public in the U.S. and Canada,
it must be tested and certified to the FCC and Industry Canada that it does not
exceed the limit established by each government for safe exposure. The tests
are performed in positions and locations (e.g., at the ear and worn on the body)
submitted to the FCC and available for review by Industry Canada. The highest
SAR value for this mobile device when tested for use at the ear is 1.08 W/kg,
and when worn on the body, as described in this guide, is 0.423 W/kg.
Body-worn measurements can differ, depending upon available accessories and
regulatory requirements. The SAR information includes the Motorola testing
protocol, assessment procedure, and measurement uncertainty range for this
product. While there may be differences between the SAR levels of various
mobile devices and at various positions, they meet the governmental
requirements for safe exposure. Please note that improvements to this product
model could cause differences in the SAR value for later products; in all cases,
products are designed to be within the guidelines.
Additional information on SAR can be found on the Cellular Telecommunications
&Internet Association (CTIA) Website:
http://www.phonefacts.net
or the Canadian Wireless Telecommunications Association (CWTA) Website:
http://www.cwta.ca
FCC Notice to Users
FCC Notice
The following statement applies to all products that bear the FCC logo
and/or FCC ID on the product label.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. See 47 CFR Sec. 15.105(b).
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or