Automobile Accessories User Manual

16 MW810 Mobile Workstation Vehicle Installation Manual
Connection to Standard Personal Computer
12.1” Display to DVI (or RGB) Standard CPU Cable enables to interface the MW810, 12.1”
Display to any personal computer.
Interfacing the MW810, 12.1” Display to a standard
laptop or personal computer with DVI
connection requires the following components:
• 12.1” Display to DVI Standard CPU - P.N: FKN8454
• Adaptor Cable - FKN000100
Interfacing the MW810, 12.1” Display to a standard
laptop or personal computer with RGB
connection requires the following components:
• 12.1" Display to RGB Standard CPU - P.N: FKN84493
• Adaptor Cable - FKN000100
For cable connection, refer to Figure 10.
To comply with safety regulations, the distance between the
display mounting location and people sitting inside the vehicle
must be more than 8 inches (20cm).
!
Warning
• Long Display Signal Cables (longer than 3 Meters, 10 feet) should be routed
inside protective ducts to avoid damage.
• The MW810 Mobile Workstation Display is shipped with a protective film that
covers the touch screen. Once installation is completed, the protective film must
be removed to avoid damage to the touch screen during operation. If any residue
from the protective film remains upon removal, use a dry soft cloth and gently
rub it off, toward the center of the display so it does not wedge into the bezel of
the touchscreen.
!
Caution
USB Connector
(male type)
Speaker Jack
Standard Laptop or
Personal Computer
12.1” Display to DVI (or RGB)
Standard CPU Cable
DVI or RGB
Connector
Figure 10
Connection of MW810, 12.1” Display to a Standard Personal Computer
Not used (Green wire)
12.1 MW810 Display
Adaptor Cable