Automobile Accessories User Manual

Installation 23
To mount the DIN sleeve inside the radio slot, perform the following steps:
Step 1. Remove the radio (if exists) from radio
slot in the vehicles dash.
Step 2. Route the display signal cable and the po
wer cable through the radio slot in the
vehicles dash.
Step 3. Slide the DIN sleeve into the slot in the vehic
l
e dash and route the display signal
cable and the power cable through the sleeve.
Step 4. When the sleeve is fully inserted
and the front edge or lip is seated, secure the sleeve
to the radio slot by bending the tabs on the sleeve behind the plastic of the dash.
The DIN mount can only be adjusted during installation and may
require reinstallation before the final position is determined. No end-
user adjustment is available.
The following installation steps may change according to your specific
vehicle
model and application requirements.
To ensure maximum safety, the DIN sleeve
must be fastened to the
vehicle using the back, and/or side and bottom anchor holes.
Note
DIN Mount Sleeve
Ta b s
Radio (DIN) Slot
Side Anchor Holes
Figure 15
8.4” Display - Installation of DIN Sleeve
Bottom Anchor Holes
Back Anchor Holes
!
Warning