Automobile Accessories User Manual

24 MW810 Mobile Workstation Vehicle Installation Manual
To assemble and install the Display DIN Mount, perform the following steps (see Figure 16):
Step 1. Position the left-hand side and right-hand side Arm Brackets inside the DIN Sleeve.
Use the holds on
the arms to determine the distance of the display from the dash, and
fasten the arms using four nuts to inner studs.
Step 2. Use four screws to connect the left-hand
side and right-hand side Arm Brackets to the
Tilt Bracket. Pivot the Tilt Bracket up/down to determine the display tilt position and
secure the four screws.
Step 3. Route the display signal cable and the power cable through the opening in the T
ilt
Bracket.
S
tep 4. Use four screws to connect the Swivel Bracket
to
the Display Bracket. Use the line of
holes on the Display Bracket enable to determine the display height position and
connect the display using four screws.
Vehicle vibrations may loosen the mount parts. It is very
important to use the spring washers when assembling the
display mount.
Swivel Bracket
Tilt Bracket
Arm Bracket
Arm Bracket
Display Bracket
Swivel Plate
Figure 16
8.4” Display - DIN Mount Breakdown
DIN Mount Sleeve
Note