Automobile Accessories User Manual

26 MW810 Mobile Workstation Vehicle Installation Manual
Step 9. Assemble the Swivel Bracket (connected to the VESA plate) to the Tilt Bracket. The
Swivel Bracket determines the pivot position of the display.
Step 10. Use the center screw slot on the Swivel Bracket
to align the display and set the
swivel angle, then fasten using the two side screws and Swivel Plate.
Connection to Standard Personal Computer
The Laptop to MW810, 8.4” Display Signal Cable (optional DVI, P.N: FKN8547 or RGB,
P.N: FKN8546 cable) enables you to interface the MW810, 8.4” Display to any laptop or
personal computer. For cable connection, refer to Figure 18.
The following table describes the connectors of the
MW810, 8.4” Display to Laptop or
Standard Personal Computer.
Connector Description
RGB or DVI RGB or DVI signals from the personal computer to display.
USB 2.0 USB communication with the personal comput
er.
This communication enables operation of the
function buttons,
emergency button and Power button for turning the workstation
On/Off.
Speaker Jack Audio signal from the personal computer to display speaker.
USB Connector (male type)
Speaker Jack
Standard Laptop or Personal Computer
Laptop to MW810, 8.4” Display Signal Cable
RGB or DVI Connector
Figure 18
Connection of MW810, 8.4” Display to Laptop or Standard Personal Computer
Not used (Green wire)
Optional Left Exit Cable