Automobile Accessories User Manual

Installation 29
Hard Disk Drive/Solid State Disk Compartment
The CPU Box is supplied with a removable Hard Disk Drive (HDD) or Solid State Disk
(SSD) that interfaces to the CPU Box enclosure via a SATA3 connector.
R2.0 CPU Boxes do not support legacy R1.X HDD
or SSD enclosures. 
Legacy R1.X HDD or SSD enclosures are not interchangeab
le with R2.0 enclosures. To
Identify R2.0 HDD or SSD, look for the R2.0 mark on the front panel of the enclosure.
The HDD is equipped with a built-in heater that automatically
turns on at low temperatures.
When the temperature drops below 41°F (5°C), a built-in heater starts operating to maintain
the HDD in working conditions. If the HDD temperature is below 41°F (5°C) during boot-
up, a message is issued indicating that the heater is starting to operate and slightly delaying
start-up due to time-out of HDD heater function.
To remove the HDD/SSD unit:
Step 1. Shut down the MW810 Mobile Wo
rkstation.
Step 2. Switch off the On/Off power switch located at the backpanel of the CPU Box (see
Figure
3).
Step 3. Loosen the two screws securing the HDD/SSD Unit to the CPU Box (see Figure 6).
Step 4. Pull out the HDD/SSD
Unit
from the HDD/SSD Unit Compartment in the CPU Box.
Figure 22
CPU Box - Removal of Hard Disk
Drive/Solid State Disk Unit
The SSD does not require/include a heater to operate at low
temper
atures.
Note
HDD/SSD Unit
HDD/SSD Unit Compartment
Screws
CPU Box