MOTOROLA Radio Service Software RSS Software GP60 Series
MOTOROLA Radio Service Software: MAIN MENU The MAIN Menu is the top level of the program from which you select the type of function that you wish to perform. All selections are made via the "Function Keys", labeled F1 thru F10, on your keyboard. Press the ESCape key to return to the MAIN Menu from any where in the program. After making a selection, you will be directed to similar menus and / or data entry screens for RF alignment or codeplug data.
SERVICE All radio alignment procedures are accessed from the SERVICE menu. A radio must be connected to your computer via a RIB and cables and the radio turned on before you will be permitted to access the SERVICE screens. !!! WARNING !!! Do NOT switch radios in the middle of any SERVICE procedure. Always use the EXIT key to return to the previous menu screen before disconnecting the radio.
DEVIATION Transmitter Deviation is increased or decreased by first keying the radio via F6, and then by pressing the UP/DOWN arrow keys respectively. A relative deviation value will be displayed, but the actual transmitter deviation must be determined from your service monitor. The radio will transmit on the test frequencies displayed on the screen and should be terminated into a 50 ohm load or service monitor. Using the UP/DOWN arrow keys, adjust Tx Deviation per your User's Manual.
Using the UP/DOWN arrow keys, adjust the Transmitter Power per your User's Manual. Press F6 again to de-key the radio, and the value will be programmed into the radio. NOTE: For fast changes, keyin the value and press the Enter button. BATTERY THRESHOLD ADJUSTMENT This aligment screen adjusts the battery threshold value for NICAD and ALKALINE battery threshold used by the radio. RX values indicate battery threshold while in receive mode, while TX values indicate battery threshold while in transmit mode.
F8 - The PROGRAM CODEPLUG function is used to transfer codeplug information from the computer to the radio codeplug. The time required to PROGRAM a codeplug will depend directly on your computer type and the size of the codeplug you are programming. The status of the PROGRAM operation will be displayed on the screen. CHANGE/VIEW CHANGE/VIEW is a multi-level menu that is used to change, view, or modify codeplug features and option configurations.
SYSTEM This screen allows you to configure one or more signaling systems. These signaling systems will be used by the Call List and Mode screens to determine when and where decode or encode. TYPE When this screen is displayed the cursor is placed on the TYPE data field. The available system types are QCII (QUIK CALL) and GENERIC. The system types are selected by using the Up/Down arrow keys. ID QCII QCII ID corresponds to tones A and B. It requires at two unique tones. The defaults are 358.
Cloning Cable Pinout Programming Cable Pinout The programming cable is used for aligning the radio with the Motorola Radio Service Software (RSS). The RSS has NO other function than to service the radio, it is not for programming modes, editing repeater offsets, changing the scan list, changing frequencies, etc. When you read the radio you only see some very basic information (bandsplit and model number).