Universal Bluetooth® Headset H270 H270 MOTOMANUAL
Figure 1 1 2 3 5 6 4 Figure 2 1
Figure 3 Figure 4 2
English European Union Directives Conformance Statement Hereby, Motorola Inc., declares that this H270 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can view your product’s Declaration of Conformity (DoC) to Directive 1999/5/EC (the R&TTE Directive) at www.motorola.com/rtte. Caring for the Environment by Recycling When you see this symbol on a Motorola product, do not dispose the product with household waste.
English Before you begin See figure 1 on page 1. Take a moment before you get started to familiarize yourself with your new H270 Headset. 1. 2. 3. 4. 5. 6. Volume button Speaker Call button Power switch Indicator light Microphone Charging your headset See figure 2 on page 1 Verify slide switch is in the off position (toward the charging port). The indicator light turns on when the battery is charging. It may take up to 60 seconds for the indicator light to turn on.
English Wearing your headset You can wear your H270 headset on your left or right ear. The headset comes ready for the right ear. Placing the headset on your right ear : See figure 3 on page 2 Placing the headset on the left ear : See figure 4 on page 2 Turning headset on and off To turn ON your headset, slide the switch toward the microphone.
English Pairing your headset Your phone’s Bluetooth feature is off by default. To use your headset, turn on the Bluetooth feature in your phone. Please check your phone’s user’s guide. Note : The Bluetooth feature remains on until you turn the feature off. Before you can use your headset, you must pair it with your phone. 1 Ensure headset is in pairing mode Power on headset by sliding the Power switch towards the microphone to initiate easy pairing.
English Test and use Your phone and headset are now paired and ready to make and receive calls. To confirm they are successfully paired and operating properly, place the headset over your ear and make a call from your phone. You will hear ringing from the headset. After you have successfully paired your phone and headset, you do not need to repeat these steps each time you use the headset. Note: If desired, your headset can be restored to original factory settings.
English Indicator lights Charging status (with charger plugged in) Headset Indicator Red Headset Status Charging (below 70% charge) Purple Charging (above 70% charge) Blue Charging complete Operating status (with no charger plugged in) Headset Indicator Off Headset Status Power off 3 blue flashes Powering on/off Steady blue Pairing mode Rapid blue/purple flashes Connection successful Quick blue flash Incoming/outgoing call Slow blue pulse Connected (on a call) Slow blue flash Standby (not on
English Audio tones Audio Tone Ascending tone Headset Status Powering on 2 descending tones Powering off Ring tone Incoming call 1 Short tone when pressing Volume button Volume level (high, medium, or low) High/low tones repeated every 60 sec.
English Troubleshooting My headset will not enter pairing mode Make sure that any devices previously paired with the headset are turned off. If the indicator light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode.
motorola.com MOTOROLA and the Stylized M Logo are registered in the US Patent & Trademark Office. All other product or service names are the property of their respective owners. The Bluetooth trademark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Motorola, Inc. is under license. © 2008 Motorola, Inc. All rights reserved. 6803578F65 - Printed in the EU.
