Owner`s manual

21
Installation
4.
Detach the green cord attached to the ring element and store it on the spool. This
cord is not used in sloping antenna erection.
5.
Release as much of the green antenna wire as required, depending on the specific
location (maximum 18m (60 ft)).
6.
Lock the antenna wire into the hook of the spool.
7.
Unwind as much of the cord connected to the spool as required, depending on the
specific location, and tie the cord to the antenna support.
8.
Connect the lug at the end of the antenna wire to the Antenna terminal on the left
side of the tuner.
9.
Tighten the antenna to remove any slack. The wire should be tense, but not so
tight as to stress the lug connection.
Figure 7: Erecting a Sloping Long-Wire Antenna
Coaxial
cable
MICOM-
2ET-RDP
Adjustable cable
maximum 60 ft.
Cord
Spool
Tuner
Pole or
other high
support
Ground
lead
Ground Level