Owner`s manual

MICOM-2ET-RDP HF-SSB Owner’s Manual

Transmitter

Output power: 125W P.E.P. and average

Reduced power levels: 25W, 62W, 100W (RSS programmable)

Audio bandwidth ripple: 3 dB

Intermodulation: -31 dB/P.E.P. (-35 dB/P.E.P. typical*)

Harmonic emissions: -64 dB/P.E.P. (-70 dB/P.E.P. typical*)

Spurious emissions: -64 dB/P.E.P. (-70 dB/P.E.P. typical*)

Carrier suppression: -50 dB/P.E.P.

Undesired sideband supp.: -55 dB/P.E.P.

Audio distortion: 2.5%

1/2 power mic. sensitivity: 25 to 125 mV (RMS) / 600 Ohm

Hum and ripple: -50 dB

Inband noise: -60 dB (30 Hz BW)

Tx/Rx switching time: 10 msec

Tx tuning adjustments: none

Receiver

Sensitivity (SINAD) SSB: 0.5

v for 10 dB SINAD

(Voice): (0.3

v typical*)

0.1-1.6 MHz – reduced performance

1/2 rated power sensitivity: 1

v for 2.5 W audio @ speaker

Selectivity: -6 dB @ 350 to 2700 Hz

-60 dB @ -1 kHz, +4 kHz

Image: -80 dB

IF: -85 dB

Undesired sideband: -55 dB @ -1 kHz

Spurious: -80 dB

* Values noted as typical are valid over 90% or more of the frequency range.

Intermodulation: -80 dB

Cross modulation: -100 dB @ 100 kHz

Desensitization: -100 dB @ 100 kHz