Service manual

FEATURES, ICONS, AND INDICATORS: Display Icons
68P80401P01-O 2-3
2.2.2 Status Icons
Status icons appear in the two rows at the top of the display. Some appear at all times. Others appear
only when your phone is engaged in certain activities or when you have activated certain features.
Battery Strength—Indicates the battery’s stored level of charge.
The Battery Strength icon exhibits a darkened area inside the simulated battery image to
indicate the level of stored charge. The levels of charge are shown in the display with or
without the charger attached. A depleted battery has little or no darkened area. As the
battery is charged, the levels of darkened area increase until the battery is fully charged. As
the battery is depleted, the darkened area decreases.
Signal Strength—Indicates the device is registered and the strength of the network signal.
The antenna portion of the icon is always displayed. Up to 4 bars are displayed next to the
antenna. The more bars depicted, the stronger the signal. One bar = approx. 19 SQE and >-
103 RSSI, 4 bars = approx. 29 SQE and >-88 RSSI. When the unit is in a no-service state,
or the signal is less than 19 SQE or <-103 RSSI, no bars appear next to the antenna.
No Service — your phone is without service. You cannot make or receive any type of call.
Phone In Use — your phone is active on a phone call.
Private In Use — your phone is active on a Private call.
Talkgroup In Use — your phone is active on a Group Connect call.
SDG Call In Use — unit active on an SDG call.
Active Phone Line — 1 indicates phone line 1 is ready to make calls; 2 indicates phone
line 2 is ready to make calls.
Bluetooth in Use — your phone is using Bluetooth. If this icon is blinking, then your phone
is in discoverable mode. If this icon is static, your phone is active in a Bluetooth connection.
Call Forward — your phone is set to forward calls.
Ringer Off — your phone is set not to ring.
Speaker Off — Sounds associated with Private calls and group calls are set to come
through the earpiece rather than through the speaker.
Messages — you have one or more messages.
Internet — you are ready to browse the internet or are browsing the internet.
Transmitters — your phone is set not to receive calls and other transmissions.
Audio Player — The audio player is active.
Packet Data — you are ready to transfer packet data or are transferring packet data using a
data cable.
Hearing Aid — your phone is set for use with a hearing aid.
TTY— Indicates that unit is connected to a TTY device and TTY mode is enabled. You can
select either VCO (voice-carry-over) or HCO (hearing-carry-over) mode.
Roaming — You are using your phone outside your carrier’s network.